hi to all
i just purchased this amazing philips 17 inches set from a local advertisement for only 60€
i replaced the tar capacitors (across the line and boosterspannung capacitor)
also replaced the capacitor from the pl36 heater to ground wich normally fails
it had a broken wire on the crt socket and a bad power switch
after those repairs it is working with a very nice picture
Dateianhang:
WP_20180920_18_34_50_Moment.jpg [ 54.44 KiB | 4265-mal betrachtet ]
but i have 2 problems:
- focus voltage is low, should be 500v and it is 375v
focus potentiometer and resistors are good
- i want to reduce the image width but i dont know how
- the 400ma (+2) fuse blows and i have to use a larger fuse, this fuse feeds power (+2) to the py88 valve
i checked all the elkos and changed py88 pl36 and high voltage rectifier valve and also horizontal oscillator valve with new valves i had in my stock
it did not fix the "problem"
Dateianhang:
1.jpg [ 106.66 KiB | 4265-mal betrachtet ]
Dateianhang:
12.jpg [ 70.13 KiB | 4265-mal betrachtet ]
the tv is working fine but i want to solve this because the large picture can cause overheating of the flyback and the fuse blowing may indicate excess current draw from the horizontal circuit
can any of you gyus give me some hints?
translated with google:
Hallo an alle
Ich habe gerade dieses erstaunliche Philips 17 Zoll Set von einer lokalen Werbung für nur 60 € gekauft
Ich habe die Teerkondensatoren ersetzt (über die Leitung und Boosterspannung Kondensator)
ersetzte auch den Kondensator von der pl36-Heizung gegen Erde, die normalerweise versagt
Es hatte einen kaputten Draht an der CRT-Buchse und einen schlechten Netzschalter
Nach diesen Reparaturen arbeitet es mit einem sehr schönen Bild
aber ich habe 2 Probleme:
- Fokusspannung ist niedrig, sollte 500v sein und es ist 375v
Fokuspotentiometer und Widerstände sind gut
- Ich möchte die Bildbreite reduzieren, aber ich weiß nicht wie
- die 400mA (+2) Sicherung durchbrennt und ich muss eine größere Sicherung verwenden, diese Sicherung versorgt das py88 Ventil mit Strom (+2)
ich überprüfte alle Elkos und änderte py88 pl36 und Hochspannungsgleichrichterventil und auch horizontales Oszillatorventil mit neuen Ventilen, die ich in meinem Lager hatte
es hat das "Problem" nicht behoben